Publicité
Les langues disponibles
Les langues disponibles
Make sure that only fuses of the type stated and
rated current specified are used as a replacement.
The use of repaired fuses or bridging the fuse
bracket is not permitted.
Never operate the measurement device when it is
open. !Danger to life!
Replacing the battery
If the battery symbol
teries have to be replaced as soon as possibl to prevent erroneous
measurements.
Proceed as follows to replace the batte-
ries:
- Switch off the multimeter and remove the measuring device from
all measuring circuits.
- Turn the grey corrugated plastic ring on the rear in the anticlock-
wise direction and detach it from the measuring devices.
- Remove the light-grey covering towards the rear.
- Rplace the flat batteries with new one of the same type (2xLR44).
The batteries can be levered out of the battery holder at the side
of the housing with a measuring prod or a sharp object.
- Close the pen-type multimeter again carefully in the reverse
order.
Never operate the measurement device when it is
open. !Danger to life!
Do not leave flat batteries in the device. Even batteries protected
against leaking can corrode and thus release chemicals which may
be detrimental to your health or destroy the battery compartment.
becomes visible in the display, sthe bat-
37
Publicité
