Publicité
Les langues disponibles
Les langues disponibles
10.7 optional blower installation
WARNING
!
•
Ensure the appliance is completely cool before starting installation.
•
To avoid danger of suffocation, keep the packaging bag away from babies and children. Do not use in cribs,
beds, carriages or play pens. This bag is not a toy. Knot before throwing away.
A.
Remove the safety barrier by lifting it up and off of the appliance.
B.
Remove the door from the appliance by releasing the door latches.
C.
It may be necessary to move the control module aside during blower installation.
D.
Attach the two 1/4" connectors (black and white) from the wire harness to the thermodisc.
E.
Attach the two 1/4" connectors (black and red) from the wire harness to the blower.
F.
Install the clear bumpers supplied onto the bottom of the blower to avoid the blower rubbing against the
fl oor of the appliance.
G.
Pivot the blower into the bottom of the appliance, ensuring the gasket remains in place between the
blower and outer shell while sliding the blower against the back side of outer shell into the blower
mounting tab. Secure in place using one screw, see Figures 1 & 2.
NOTE: WITH THE ZIP TIE SUPPLIED, ENSURE ALL WIRES REMAIN CLEAR OF THE BLOWER.
FIGURE 1
MOUNTING TAB
LOCATION
SCREW
LOCATION
H.
Place the control module back into its original position. Ensure the transformer is plugged into the rear
outlet of the electrical box.
I.
The variable speed switch (VSS) will need to be disassembled to secure to the VSS bracket for installation.
Place the VSS through the mounting bracket using the lock washer to secure it in place. Take the
variable speed switch knob and install into position. (Refer to Figure 3.)
J.
To install the variable speed switch, the mounting bracket will fi rst need to be installed. Remove the two
screws securing the piezo ignitor switch bracket in place, install the VSS mounting bracket into position
then reinstall the two previously removed screws, refer to Figure 3.
K.
Plug the connector from the variable speed switch to the matching connection on the wire harness.
L.
Ensure that the thermal disc is in contact with the fi rebox base and that the wire harness is properly attached.
M.
Plug the power cord from the blower into the electrical box.
NOTE: The blower is thermally activated, so when it is turned on, it will automatically start approximately
15 minutes after lighting the appliance and will run for approximately 30 minutes after the appliance has
been turned off.
BLOWER
FIGURE 3
FIGURE 2
THERMODISC
BLOWER
fi nishing
EN
REAR VIEW
BLOWER
MOUNTING
TAB
53
W415-3036 / 05.07.21
Publicité
