Napoleon BL56NTE Manuel D'installation page 37

6.1 hard wiring connection
It is necessary to hard wire this appliance.
This appliance must be electrically connected and grounded in accordance with local codes. In the absence of
local codes, use the current CSA C22.1 Canadian Electrical Code in Canada or the ANSI/NFPA 70-1996 National
Electrical Code in the United States.
6.2 receptacle wiring diagram
L1 (Black)
Cable connector
6.3 electronic wiring diagram
WARNING
!
• Do not use this appliance if any part has been under water. Call a qualifi ed service technician immediately to
have the appliance inspected for damage to the electrical circuit.
• Risk of electrical shock or explosion. Do not wire 110V to the valve or to the appliance wall switch. Incorrect
wiring will damage controls.
• All wiring should be done by a qualifi ed electrician and shall be in compliance with local codes. In the
absence of local codes, use the current CSA22.1 Canadian Electric Code in Canada or the current National
Electric Code ANSI/NFPA NO. 70 in the United States.
• Always light the pilot whether for the fi rst time or if the gas supply has run out, with the glass door opened or
removed.
6.4 optional wall switch
WARNING
!
• Do not connect either the wall switch or gas valve directly to 110 volt electricity.
For ease of accessibility, an optional remote wall switch may be installed in a convenient location. Route a 2
strand, solid core millivolt wire from the valve to the wall switch. The recommended maximum lead length depends
on wire size:
Disconnect the existing wires from terminals 1 and 3 (from the ON/OFF switch) and replace with the leads from
the wall switch.
Electrical box
cover
Screw
Ground
L2
(Green)
(White)
WIRE SIZE MAX. LENGTH
14 gauge (1.8mm) 100 feet (30.5m)
16 gauge (1.5mm) 60 feet (18.3m)
18 gauge (1.2mm) 40 feet (12.2m)
6.0 electrical information
venting installation
3 prong
receptacle
(Black)
(White)
Wire nuts
Ground
(Green)
EN
Electrical
box
37
W415-3036 / 05.07.21