Publicité
Les langues disponibles
Les langues disponibles
10-Installation
10-4
10-5
I1
4. Fill the 6 left holes with blanking plugs (Fig. 10-6).
Note: Keep in safe place
Keep all parts of the transport protection in a safe place for later use. Whenever the ap-
10.4 Moving the appliance
If the machine is to be moved to a distant location, replace the transportation bolts removed
before installation to prevent damage: The assembly takes place in reverse order.
10-7
26
S1
R5-R10
S2
R1-R4
I2
2. Remove the 10 screws (R1 - R10) from lower back
reinforcement. take out reinforcements (S1 and
S2) from the machine(Fig. 10-4). *Only HW90/
100/120-B14979
3. Pull out the 2 iron bars I1 and I2 (Fig. 10-5).
*Only HW90/100/120-B14979
10.5 Aligning the appliance
Adjust all feet (Fig. 10-7) to achieve a complete level
position. This will minimize vibrations and thus noise
during use. It will also reduce wear and tear. We recom-
mend to use a spirit level for adjustment. Floor should
be as stable and flat as possible.
1. Loose the locknut (1) by using a wrench.
2. Adjust the high by turning the foot (2).
3. Tighten lock ut (1) against the housing.
10-6
EN
Publicité
