Alarm Setting - TFA 60.2507 Mode D'emploi

TFA_No. 60.2507 Anleitung
Radio controlled alarm clock with natural sounds
a time deviation of less than one second in one
million years. The time is coded and transmitted
from Mainflingen near Frankfurt via frequency sig-
nal DCF-77 (77.5 kHz) and has a transmitting range
of approximately 1,500 km. In Daylight Saving
Time "DST" is shown on the LCD. The quality of
the reception depends greatly on the geographic
location. In normal cases, there should be no
reception problems within a 1,500 km radius
around Frankfurt.
Please take note of the following:
• Recommended distance to any interfering sources
like computer monitors or TV sets is a minimum
of 1.5 - 2 metres.
• Within ferro-concrete rooms (basements, super-
structures), the received signal is naturally weak-
ened. In extreme cases, please place the unit close
to a window and/or point its front or back
towards the Frankfurt transmitter.
• During night-time, the atmospheric disturbances
are usually less severe and reception is possible in
most cases. The alarm clock receives the signals
at 0:00, 2:00, 4:00 and 6:00 o'clock in the morn-
ing. A single daily reception is adequate to keep
the accuracy deviation below 1 second.
• After the reception of the radio controlled time
you can set the alarm time (see 4.2. Alarm setting).
4. How to operate
4.1 Manual setting of clock and calendar
• First select with the UP 12/24 button the 12 HR
(PM appears on the display after noon) or 24 HR
system.
14
25.11.2009 16:01 Uhr
Radio controlled alarm clock with natural sounds
• Hold MODE/SET button in normal mode for 3
• Using MODE/SET button you can switch to setting
• The time zone is used for countries where the
• Holding UP 12/24 or DOWN °C/°F button, you will
• The instrument will quit automatically the setting

4.2 Alarm setting

• To enter alarm mode, press MODE/SET button in
• AL appears on the display.
• To activate the alarm press UP/12/24 button in
• The alarm symbol will appear on the display.
• Holding MODE/SET button and the hour digit is
• Set minutes in the same way.
• Confirm with MODE/SET button.
• Press MODE/SET button again and you will return
Seite 8
seconds. The hour digit is flashing. Press UP 12/24
or DOWN °C/°F button to adjust hours.
minutes, year, month, day and time zone (+12/
-12) and adjust with UP 12/24 or DOWN °C/°F but-
ton.
DCF signal can be received but the time zone is
different from the German time (e.g. +1=one
hour later).
enter fast mode.
mode, if there is no button used within 20 seconds.
normal mode.
alarm mode.
flashing. Press UP 12/24 or DOWN °C/°F button to
adjust hours. Holding UP/12/24 or DOWN/°C/°F
button in setting mode and you will enter fast
mode.
to normal mode.
15