Time Zone Setting; Alarm Time Setting - TFA Tune Mode D'emploi

TFA_No. 60.2546_anl_04_20 02.04.2020
TUNE – Radio-controlled alarm clock with radio
• Press the MODE button again and the setting sequence is shown as follows: the 24 or 12 hours display (default: 24 Hr),
hours and minutes. Adjust with the UP or DOWN button.
• Confirm the setting with the MODE button.
• The manually set time is overwritten once the DCF time signal is successfully received.

7.1.2 Time zone setting

• You can make the time zone correction (-12/+12) in setting mode.
• The time zone correction is needed for countries where the DCF signal can be received but the time zone is different from
the DCF time (e.g. +1=one hour plus).
7.1.3 24- or 12-hour system setting
• In setting mode you can choose between the 12 - or 24 hour system.
• In the 12-HR system AM (before noon) or PM (after noon) appears on the display.

7.2 Alarm time setting

• Press the MODE button in normal mode to enter the alarm mode.
• AL and 6:00 (default) or the last adjusted alarm time appear on the display.
• Press and hold the MODE button for three seconds to enter the setting mode.
• The hour digits flash.
26
15:01 Uhr Seite 14
– 26 –
TUNE – Radio-controlled alarm clock with radio
• Press the UP or DOWN button to set the desired time.
• Confirm with the MODE button.
• Set the minutes in the same way.
• Confirm with the MODE button.
• You can now set the snooze interval.
• 05 (default) or the last adjusted snooze interval appear on the display.
• Press the UP or DOWN button to set the desired time duration (5 to 60 minutes).
• Confirm with the MODE button.
7.3 Activate and deactivate the alarm
• To activate or deactivate the alarm function press the DOWN button. The alarm symbol appears/disappears on the display.
• When the alarm is activated, the alarm starts to ring when the set alarm time is reached.
• Press any button (except SNOOZE) and the alarm will stop.
• If the alarm is not stopped manually, the alarm tone automatically turns off after two minutes and will be reactivated at the
same set time on the following day.
• The alarm symbol remains on the display.
• When the alarm rings, press the SNOOZE button and the snooze function is activated.
• Once the snooze function is activated, the snooze symbol will be flashing on the display.
• The alarm will be interrupted for 5 minutes (default).
– 27 – 27