Publicité
Les langues disponibles
Les langues disponibles
Problem
If the advice does not lead to the
desired result, call the nearest
Authorized Service Centre.
Replacing the lamp
Disconnect the plug from the mains socket.
1. Remove the screw from the lamp cover.
2. Remove the lamp cover (refer to the
illustration).
Installation
WARNING!
Refer to Safety chapters.
Positioning
This appliance can be installed in a dry, well
ventilated indoor where the ambient
temperature corresponds to the climate class
indicated on the rating plate of the appliance:
www.zanussi.com
Possible cause
The door is not closed correctly.
The food products' temperature
is too high.
Many food products are stored at
the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened often. Open the door only if necessary.
There is no cold air circulation in
the appliance.
3. Replace the used lamp with a new lamp of
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door.
Make sure that the light comes on.
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to
3. If necessary, replace the defective door
Climate
SN
N
ST
T
Refer to "Closing the door".
Let the food products tempera-
ture decrease to room tempera-
ture before storage.
Store less food products at the
same time.
Defrost the appliance.
Make sure that there is cold air
circulation in the appliance.
the same power and specifically designed
for household appliances (the maximum
power is shown on the lamp cover).
"Installation".
gaskets. Contact the Authorised Service
Centre.
Ambient temperature
class
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
Solution
47
Publicité
