Bosch MUZ4MX300 Notice D'utilisation page 7

Risk of burns!
Risk of scalding!
Caution when processing hot liquids.
If processing hot liquids, steam escapes
through the funnel in the lid.
Add a max. 0,5 litres of hot or frothing
liquid.
Warning!
Process liquids at maximum setting 3.
Add a max. 0,5 litres of hot or frothing liquid.
Fig. 
Press release button and move

swivel arm into the operating
position.
Remove the blender drive cover.

Attach blender (mark on the blender

holder on mark on the base unit) and
turn it all the way anti-clockwise.
Add ingredients.

– Maximum amount of liquid ingre-
dients = 0,75 litres;
– Maximum amount of frothing or hot
liquids = 0,5 litres;
– Optimum processing amount of solid
ingredients = 50–100 grams.
Observe upper fill mark!
Attach the cover.

Note position of the seal.
Insert the mains plug.

Set the rotary switch to the desired

setting.
Adding more ingredients (Fig.
Switch off the appliance with the rotary

switch.
Remove the lid and add ingredients

or
remove the funnel and gradually add

solid ingredients through the refill
opening
or
pour liquid ingredients through the funnel.

Important information
When processing liquids/liquid ingre-
dients, slowly increase the speed
of the appliance in stages to prevent
the food from shooting out.
Operate appliance at maximum setting 3.
Robert Bosch Hausgeräte GmbH
After using the appliance




Tip: It is recommended to clean the blender
immediately after use.
Cleaning and servicing
Taking the blender apart
Fig. 



Cleaning the blender
Warning!
Do not clean the blade insert in the dish-
washer, but under running water (do not soak
in water).
-10)
 


Tip: After processing liquids, it is often
sufficient to clean the blender without
removing it from the appliance.
Pour a little water and washing-up liquid into
the attached blender.
Switch on the blender for several seconds
(setting M). Pour out the water and rinse
out the blender with clear water.
Switch off the appliance with the rotary
switch. Wait until the blade has come
to a standstill.
Remove mains plug.
Rotate the blender in a clockwise
direction and remove.
Take the lid off the blender jug.
Risk of injury from sharp blades!
Do not touch blender blades with bare
hands. Clean them with a brush.
Turn blender jug clockwise (left-handed
thread) and remove it from the blender
holder.
Take blade insert out of the blender
holder.
Caution. Risk of injury from sharp blades!
Remove seal from the blade insert.
Clean blade insert under running water.
To clean thoroughly, the seal can
be removed from the lid.
Blender holder, seals, lid, funnel and
blender jug can be washed in the
dishwasher.
en
7