SOMFY Amy 1 sun protect Modes io Notice page 9

Amy 1 sun protect Modes io
2.5.2.Wall mounting with circular back cover
2.5.2.1. Using double-sided tapes
NOTICE
The product is designed to be fixed to most wall surfaces, such as paint, wallpaper, earthenware, wood, varnished
wood, primer/coating. However the walls must be flat and clean.
1] Remove the protective films from the double-sided tapes.
2] Take the provided circular back cover and stick the double-sided tapes on its
back.
3] Remove the second protective films from the double-sided tapes already
sticked.
4] Following the orientation indicated inside the circular back cover, press it on a
flat, clean, and dry surface. Make sure it is firmly fastened to the surface.
NOTICE
Make sure Amy 1 sun protect Modes io is switched on before clipping the module
(refer to Switching on Amy 1 sun protect Modes io).
5] Clip the Amy 1 sun protect Modes io module onto the circular back cover.
Press firmly on the front of the module, on the right and left near the my
button as close as possible to the translucent circle without pressing on the
edges of the module (to avoid unwanted radio transmission), until it clicks into
place.
2.5.2.2. Using screws
CAUTION
• Do not use an electric screwdriver.
• The order of assembly must be followed to ensure that the parts fit together correctly and don't get damaged.
1] Drill 2 horizontal holes through the indicated drill marks on each side inside
the circular back cover.
2] Fix the circular back cover using screws appropriate for hole size and wall
type, following the orientation indicated inside the circular back cover.
NOTICE
Make sure Amy 1 sun protect Modes io is switched on before clipping the module
(refer to Switching on Amy 1 sun protect Modes io).
3] Clip the Amy 1 sun protect Modes io module onto the circular back cover.
Press firmly on the front of the module, on the right and left near the my
button as close as possible to the translucent circle without pressing on the
edges of the module (to avoid unwanted radio transmission), until it clicks into
place.
2.6.Use as a remote control
CAUTION
The positioning of Amy 1 sun protect Modes io is crucial for correct temperature measurement: the use as a remote
control is not recommended. However, if it is used as a remote control without being wall-mounted, care must be
taken to ensure that the circular back cover is securely attached to Amy 1 sun protect Modes io module to protect the
back access from any risk of damage and avoid accidental activation.
©
Copyright 2024 SOMFY ACTIVITES SA. All rights reserved.
1]
2]
Designed in France
3]
Designed in France
Designed in France
4]
5]
1]
2]
3]
EN
Designed in France
9