SOMFY Amy 1 sun protect Modes io Notice page 15

Les langues disponibles

Amy 1 sun protect Modes io

3.5.3.Adjusting the sensitivity threshold of Amy automation

By default, the sensitivity threshold is set to 3.

The sensitivity threshold can be adjusted (between 1 and 5 levels).

To adjust the sensitivity threshold of Amy automation:

1] Press and hold the T°/Mode button to activate setting mode: the settings feedback LED (on the back) lights up

green then orange, the feedback LED (on the front) lights up green.

2] To check which level is selected: briefly press simultaneously the Up and Down buttons.

◦ The orange settings feedback LED (on the back) and the green feedback LED (on the front) blink to indicate the

selected level by the number of flashes:

Front feedback LED

Green

3] To adjust the setting to the new desired threshold: briefly press the Up or Down button to increase or decrease the

threshold level.

◦ After each press, the orange settings feedback LED (on the back) and the green feedback LED (on the front) blink to

indicate the new selected level by the number of flashes.

4] To exit setting mode, repeat step 1 (or wait for 10 s to exit automatically).

3.6.Use with TaHoma

The embedded temperature sensor in Amy 1 sun protect Modes io can also work in combination with TaHoma where it

appears as an indoor temperature sensor.

CAUTION

When using Amy 1 sun protect Modes io with TaHoma, local mode no longer works: the selector switch to allow/

inhibit orders from Amy automation is no longer active.

When Amy 1 sun protect Modes io is added in TaHoma application and the temperature feedback to TaHoma is activated

on Amy 1 sun protect Modes io, the sensor measures the temperature inside the room (around Amy 1 sun protect Modes

io) and sends the measured values to TaHoma. These temperature values can be consulted in TaHoma and can then be

used for scenes to optimize home automation.

CAUTION

Be careful in case of wind!

Automation provided by TaHoma and Amy 1 sun protect Modes io allows the automatic use of a motorised product

when the temperature of the room equals a certain threshold, without consideration of the wind.

To maximize the protection of the motorised product from the wind and limit the risk of breaking, use a wind sensor

paired with the motorised product (sold separately).

In any case, a wind sensor does not protect against sudden gusts of wind. In the event of such weather risks,

deactivate the embedded temperature sensor (see below).

Number of flashes

blink 1 time

blink 2 times

blink 3 times

blink 4 times

blink 5 times

Level of threshold selected