SOMFY Amy 1 sun protect Modes io Notice page 10

EN
1] Take the circular back cover and clip the Amy 1 sun protect Modes io module
onto it, following the orientation indicated inside the circular back cover.
Press firmly on the front of the module, on the right and left near the my
button as close as possible to the translucent circle without pressing on the
edges of the module (to avoid unwanted radio transmission), until it clicks into
place.
2] Amy 1 sun protect Modes io can therefore be used as a remote control that
can be put down and moved around.
2.7.Tips and advice on installation
2.7.1.Questions about the product?
Observations
The selected motorised product does not react
at all when a button on Amy 1 sun protect
Modes io is pressed (No LED reaction when
pressing the buttons).
The selected motorised product does not react
at all when a button on Amy 1 sun protect
Modes io is pressed (No LED reaction in the
front when pressing a button AND in the back
when pressing the On/Off button).
The selected motorised product does not react
at all when a button on Amy 1 sun protect
Modes io is pressed but the LED lights up.
The selected motorised product does not react
at all when a button on Amy 1 sun protect
Modes io is pressed but the LED lights up and the
control point is paired with this motorised
product.
The selected motorised product does not react
as it should.
The motorised product does not react when the
indoor temperature rises (Amy 1 sun protect
Modes io is used in local mode).
The motorised product does not react when the
indoor temperature rises (Amy 1 sun protect
Modes io is used with TaHoma and the scenes
programmed in TaHoma in the event of a
change in indoor temperature do not launch).
The motorised product reaction does not stick
to my sensitivity to temperature: the sun
protection lower too early or too late.
10
Possible causes
Amy 1 sun protect Modes io is
switched off, the front panel
buttons (Up, Stop/my, Down) are
deactivated.
The control point battery is low.
The control point is not paired with
this motorised product.
External radio equipment is
interfering with the radio reception.
The selected mode does not match
the type of motorised product.
Amy automation is deactivated.
The temperature feedback to
TaHoma is deactivated.
Amy 1 sun protect Modes io
temperature threshold is not
adapted.
Copyright
Amy 1 sun protect Modes io
Solutions
Switch it on to activate the buttons
(refer to Switching on Amy 1 sun
protect Modes io).
Change control point battery as
required (refer to Replacing the
battery).
Refer to Adding/Deleting Amy 1
sun protect Modes io.
Turn off any nearby radio
equipment.
Refer to Mode selection.
Refer to Allow/Inhibit orders
from Amy automation.
Refer to Activation/Deactivation
of the temperature feedback.
Adjust the sensitivity threshold,
refer to Adjusting the sensitivity
threshold of Amy automation.
©
2024 SOMFY ACTIVITES SA. All rights reserved.