SOMFY Amy 1 sun protect Modes io Notice page 17

Amy 1 sun protect Modes io
1] Insert a flat screwdriver inside the hole at the bottom of the circular back
cover to easily eject the module from its support or, if the mounting plate and
its square frame are being used, manually remove the module from its
supports by pulling it towards you.
2] On the back of the module, remove first side of the battery cover by pushing
on the clip. Then pulling on the middle part of the battery cover to release the
first side of the cover. Push on the second clip to completely release the
cover.
3] Remove the battery cover.
4] Insert a CR2032 battery (3 V) with the (+) polarity side visible (on top), Slide it
and push to engage on the right side of the battery contact. Then insert the
stops of the cover on the bottom.
CAUTION
• Ensure you comply with the polarity.
• The power supply terminals must not be short-circuited.
5] Press on the top of the cover to engage the clips.
6] Clip the module onto the circular back cover or onto the square frame and
clip the square frame assembly onto the mounting plate again.
3.8.Tips and advice on use
3.8.1.Questions about the product?
Observations
The selected motorised product does not react
at all when a button on Amy 1 sun protect
Modes io is pressed (No LED reaction when
pressing the buttons).
The selected motorised product does not react
at all when a button on Amy 1 sun protect
Modes io is pressed (No LED reaction in the
front when pressing a button AND in the back
when pressing the On/Off button).
The selected motorised product does not react
at all when a button on Amy 1 sun protect
Modes io is pressed but the LED lights up.
The selected motorised product does not react
at all when a button on Amy 1 sun protect
Modes io is pressed but the LED lights up and the
control point is paired with this motorised
product.
The selected motorised product does not react
as it should.
The motorised product does not react when the
indoor temperature rises (Amy 1 sun protect
Modes io is used in local mode).
©
Copyright 2024 SOMFY ACTIVITES SA. All rights reserved.
Possible causes
Amy 1 sun protect Modes io is
switched off, the front panel
buttons (Up, Stop/my, Down) are
deactivated.
The control point battery is low.
The control point is not paired with
this motorised product.
External radio equipment is
interfering with the radio reception.
The selected mode does not match
the type of motorised product.
Amy automation is deactivated.
1]
2]
3]
4]
5]
Solutions
Switch it on to activate the buttons
(refer to Switching on Amy 1 sun
protect Modes io).
Change control point battery as
required (refer to Replacing the
battery).
Refer to Adding/Deleting Amy 1
sun protect Modes io.
Turn off any nearby radio
equipment.
Refer to Mode selection.
Refer to Allow/Inhibit orders
from Amy automation.
EN
17