SOMFY Amy 1 sun protect Modes io Notice page 7

Les langues disponibles

Amy 1 sun protect Modes io

NOTICE

The PROG button and the T°/Mode button are always active, even when the front panel buttons are deactivated by

the On/Off button.

2.4.Optimization of temperature sensor performance

To ensure optimum performance of the embedded temperature sensor, follow these

recommendations:

▪ Prefer wall mounting to reach higher performance of the sensor (accuracy and

repeatability). Temperature measurement will thus be more consistent with

temperature felt in the room.

▪ Avoid placing Amy 1 sun protect Modes io in direct sunlight.

▪ Place it away from any source of heat or cold (ideally 1 m from a radiator, an

air conditioner, a wood stove,...).

▪ Place it away from direct airflow (at least 25 cm from an opening).

▪ Avoid enclosed area, where the sensor will not be influenced by the

surrounding air.

2.5.Wall mounting

NOTICE

• The use of radio appliances operating on the same frequency may cause interference and reduce the product's

performance.

• Never use the control point near a metal frame or metal surfaces, as this can reduce the radio range.

• The environment in which the product is used might reduce the radio range.

• The use in the same floor as the controlled products is recommended.

• Radio range in free field: 150 m.

There are two possible ways of wall-mounting Amy 1 sun protect Modes io, depending on the type of back cover:

▪ By fixing it with double-sided tape (provided with the product).

▪ By fixing it with screws (on the wall or in a flush-mounted box).

2.5.1.Wall mounting with mounting plate and square frame

2.5.1.1. Using double-sided tape

NOTICE

The product is designed to be fixed to most wall surfaces, such as paint, wallpaper, earthenware, wood, varnished

wood, primer/coating. However the walls must be flat and clean.