Medoc ST 200 Manuel D'utilisation page 19

CAUTION: The band saw model ST 200 is heavy. Two persons are required when
lifting or moving it. The machine must be hold by the points shown at the figure
of the page 3, where weights are indicated.
5.2. ELECTRICAL CONNECTION ¡WARNING!:
1. Make sure that the line voltage of your main power source matches the rated voltage of
the machine. Except request, the machines are supplied on 230 V. for single phase current and on
400 V. for three phase current. See ch. 15 for voltage changing.
2. The outlet plug should remain at a height from the floor in between 0,6 or 1,9 meters, at sight for
the operator. In order to see that the machine is not plugged while maintaining purposes.
3. Always plug the machine to a grounded outlet.
4. Do not turn on the bandsaw if the cord or plug is damaged.
5. The F1 fuse in the plug base should be: (see wiring diagram)
MOTOR
(CV)
1
1
6. The
current breaker.
7. Verify that pulleys turn round on the way of watch hands. Otherwise the connections will have to
be changed in order to reverse the turning direction. See ch.16.
8. The electric cord should have a measure of 4x1'5mm. for three phase machines and 3x1'5mm. for
single phase machines.
6 OPERATION ¡WARNING!
1. Operating conditions: Temperature: 5-40ºC / Humidity: 30-95%.
2. Always turn off and unplug the bandsaw when no cutting product.
3. Always keep hands away from the blade zone. Use the device supplied for pushing the
product: pusher (6).
4. Only use the machine for cutting food products.
Place the product over the table(2) of the machine. Turn on the machine pressing the switch on (12).
The blade starts to move. Push the product against the blade taking the pusher handle(20) with the
left hand and holding the opposite side of the product (from the blade) with the right hand. Press
smoothly.
If you press excessively, the blade gets blended and the cut product gets twisted. If it is needed to
press excessively it means that blade must be replaced.
The product cutting is performed with a simple action of pushing, since the saw blade in
perfect sharpening conditions drowns towards the product when cutting. Therefore, the performance
is quick and without any effort.
The thickness plate (7) allows uniform thickness cuts. Unscrewing the thickness plate knob you can
place it at the position you desire. Screw again the knob for fixing the thickness plate at the desired
position.
5.1. INSTALLATION ON THE WORKPLACE
The band saw must be installed on a plain horizontal work
surface that has sufficient stability. Always maintains the
appropriate height of the table (2) from the floor, as shown in the
figure, within 850 and 950mm. Make sure the work surface will
bear the weight of the machine. See the ch.12 concerning machine
measurements for the place required for working and maintaining.
See ch.13 concerning the weight. Install the machine in a light
working area.
II (230)
(Amp.) (230/400
(Amp.)
5,3
3,8 / 2,2
III
)
machine must be connected to a leakage
- 19 -