Publicité
Les langues disponibles
Les langues disponibles
1 MACHINE DESCRIPTION
It is a stationary stainless steel bandsaw. This machine is used for cutting meat, frozen meat, bones
and other foodstuff. The band saw is fitted with a machine casing, a top and a bottom wheel, a saw
blade, a blade tensioning device, a drive and an electrical cabinet. The product is placed by hand onto
the fixed table and pushed against the cutting zone of the saw blade by the product pusher and cut.
2 SAFETY INSTRUCTIONS:
The machine is equipped with some safety devices in order to prevent hazards. All the
operators who use the band saw should read the instruction manual before using it.
"NOTE: It is very important to verify that all the safety devices (electric and mechanic devices
detailed below) perform correctly before starting a new working day.
ELECTRICAL DEVICES:
1. All push buttons and safety devices are working on safety tension 24 V. as detailed in ch.14.
2. At any case of machine stopping, the blade gets stopped before 4 seconds. Then, we offer the user
an additional safety measure to the existing blade protection, and avoiding any risks.
3. When the power is restored after a power interruption or when an interlock switch is remade the
machine does not automatically start. It is necessary to restart the machine by pressing the on switch.
In order to avoid the risk to start on the machine when not attended by the user while his/her hands
are near the cutting zone.
4. If the door cap is opened for any cleaning or maintenance operation, the machine will not start. If
the machine is working and we open the door cap, the saw blade comes to a stand-still at the latest 4
seconds after the door is opened. In order to avoid the risk to start on the machine when not attended
by the user while cleaning purposes.
5. The machine is grounded with green/yellow coloured wires which have the same section of the
wires with bigger section of the machine.
6. The electrical components of the machine are protected according to IP65.
7. The motor has a thermal protection, conform to IP65
MECHANICAL DEVICES:
1. There is the option to set a device named pusher (6) which is used for sending the product to the
blade. They minimise the risk of operator's hurting while working labours.
SYMBOLS
It is obligatory to read all the instructions
water manual before any operating on the machine.
Machine according to the Directive
2006/42/EC
3 SAFETY DEVICES SITUATION, IN CE MODELS:
See pages 2, points A, B, nº6.
4 MACHINE ELEMENTS:
See page 2.
5 INSTALLATION
- 18 -
Do not use high pressure
to clean the machine.
Danger of electrical
system.
Publicité
