Publicité
Les langues disponibles
Les langues disponibles
Warranty/technical specifications
WARRANTY AND TECHNICAL SERVICE
The conditions of the warranty and technical
service are provided on the certificate sup-
plied with your appliance.
LIMIT CONDITIONS
Temperature in the room
Outside temperature
R407c is a refrigerant that complies with the EU rules on the environment, therefore it is recom-
mended to not perforate the unit's refrigerant circuit.
At the end of its working life, take the appliance to a special collection centre.
A) If your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. If it does not fit your socket,
the plug should be cut off from the mains lead, and on appropriate plug fitted, as below. warning: Very
carefully dispose of the cut off plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in
the house as this could cause a shock hazard. With alternative plugs not incorporating a fuse, the circuit
must be protected by a 15 Amp fuse. If the plug is a moulded-on type, the fuse cover must be re-fitted
when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse
cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest elec-
trical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug.
B) If your appliance is not fitted with a plug, please follow the instructins provided below:
WARNING - THIS APPLIANCE MUST BE EARTHED
IMPORTANT
The wires in the mains lead are coloured in accor-
dance with the following code:
Green and yellow Earth
Blue
Brown
21 ÷ 32°C
21 ÷ 43°C
ELECTRICAL CONNECTION (U.K. ONLY)
Neutral
Live
TECHNICAL SPECIFICATIONS
Power supply voltage
Max. power input during
air conditioning
Max. power input during
dehumidifying
Cooling capacity*
Number of fan speeds
Max. air flow-rate
Dimensions of indoor unit:
• width
• height
• depth
• weight
Dimensions of outdoor unit
• width
• height
• depth
• weight
*
Standard conditions:
Inside temperature
Outside temperature
As the colours of the wires in the mains lead may not
correspond with the coloured markings identifying
the terminals in your plug, proceed as follows:
The green and yellow wire must be connected to
the terminal in the plug marked with the letter E or
the earth symbol
and yellow.
The blue wire must be connected to the terminal
marked with the letter N or coloured black.
The brown wire must be connected to the terminal
marked with the letter L or coloured red.
see rating plate
"
"
"
3
250-350 m
/h
450 mm
475 mm
255 mm
10 kg
570 mm
542 mm
280 mm
30 kg
27°C
47% relative humidity
35°C
41% relative humidity
or coloured green or green
3
33
Publicité
