Publicité
Les langues disponibles
Les langues disponibles
POSITIONING THE INDOOR UNIT
Install the appliance inside the room being
air-conditioned. In general, near a window or
door. In any case, near a perimeter wall.
The indoor unit must be positioned on an
even surface, where possible on a table, or
other piece of furniture (see Figures 1 and 2).
There must be no obstructions to the air intake
6
(rear grilles
) and outlet (top outlet grille
3
)on the indoor unit.
NOTE: The appliance must be positioned at
least 20/30cm from any walls.
POSITIONING THE CONNECTION SHEATH
9
The sheath
connecting the outdoor and
indoor units can be passed through the gap in
a window or door left ajar; use the suckers
to prevent them from opening further.
Permanent installation is possible by purcha-
sing the accessories and wall brackets from a
De'Longhi service centre or reseller.
22
Pre p a r i n g f o r u s e
fig. 1
fig. 2
20
USING THE QUICK COUPLINGS
As an alternative to the methods described
above, the sheath connecting the outdoor and
indoor units can be passed through an approx.
9cm diameter hole in a perimeter wall.
In this case, the outdoor unit couplings must
be disconnected as follows:
1) Unplug the appliance from the mains supply.
2) Remove the protective cover.
3) Remove the handle by unscrewing the 4
metric screws, then, to remove the cover,
unscrew the remaining 4 self-threading
screws (see Figure 3).
4) Disconnect the electrical connectors
(Figure 4).
5) Disconnect the water tubing from the
quick coupling, pressing the locking ring
and pulling out the plastic tube (Figure 4).
fig. 4
2
1
6) Disconnect the hoses using the handle on
the quick couplings, until completely ope-
ned, then move the ring on the connec-
tion back to completely disconnect the
flexible sheath (Fig. 5).
fig. 3
Publicité
