LD Systems MAUI G3 Serie Manuel D'utilisation page 13

STATUS DISPLAY
8
PROTECT:
The PROTECT indicator lights up permanently if the system is overloaded or overheats.
The integrated amplifiers are automatically muted. After reaching normal operating conditions,
the unit returns to normal operating mode after a few minutes and the PROTECT indicator goes out.
LIMIT:
Lights up when the speaker system is operated in the upper limit range. A short flash of the LIMIT
display is not critical. To protect the system, an excessive signal level is gently reduced by the integrated
limiter. If the LIMIT indicator is lit for a longer time or continuously, reduce the volume level. Failure to do
so may result in distorted sound reproduction and damage to the speaker system.
SIGNAL:
Indicator for the mixer sum signal. The signal acquisition takes place before the MAIN volume control.
POWER:
Lights up when the subwoofer is correctly connected to the mains and switched on.
FOLLOW:
Lights up when the column elements are not installed on the subwoofer. The two level controls
MAIN and SUB as well as the Bluetooth unit are deactivated in this case. Use as a follower subwoofer.
HOLD TO LINK
9
Press the HOLD TO LINK button for about 3 seconds to put the internal Bluetooth module into pairing
standby, by doing so you also disconnect from a previously paired device.
The Bluetooth symbol flashes for the duration of the pairing readiness. Activate Bluetooth on your
playback device (smartphone, tablet, etc.) and select MAUI 11G3 or MAUI 28G3 in the Bluetooth menu.
Pairing now takes place automatically; as soon as the devices are paired, the Bluetooth symbol lights
up permanently. Audio playback via Bluetooth can now be started.
CARDIOID ON / OFF
10
CARDIOID ON:
With the help of another subwoofer (same model) and the Cardioid function,
a subwoofer array with directional radiation can be realised.
The follower subwoofer is placed upright and turned horizontally by 180° directly next
to the main subwoofer (MAIN). Activate the Cardioid function in the follower subwoofer
(CARDIOID ON, see wiring example 3).
CARDIOID OFF:
Deactivate the cardioid function in the follower subwoofer (CARDIOID OFF) and place it
upright in the same orientation directly next to the main subwoofer (MAIN).
COOLING FINS
11
To prevent damage to the unit, do not cover the cooling fins on the back and ensure
that air can circulate freely.
13