Toro 37798 Manuel De L'utilisateur page 24

Adjusting the
Discharge-Chute Latch
If the discharge chute does not lock into the desired
position or does not unlock so that you can move it to
another position, adjust the discharge-chute latch.
1. Loosen the clamp fastener on the chute-support
plate until the cable is free.
Figure 38
1. Cable conduit
2. Cable clamp
2. Remove any slack in the cable by pulling the
cable conduit rearward.
3. Tighten the clamp fastener while holding the
cable in place.
Replacing the Drive Belts
If the auger/impeller drive belt or the traction-drive belt
becomes worn, oil-soaked, or otherwise damaged,
have an Authorized Service Dealer replace the belt.
g019021
3. Clamp fastener
24