Bosch Smart Home controller II Notice D'utilisation page 10

Smart Home Controller II
Download the "Bosch Smart Home" app from your app store. You will
need this for installation, configuration and operation.
QR code
for the Apple App Store
݅ To configure the controller, your mobile device must be on the same
network.
Start the Bosch Smart Home app and follow the instructions.
The Bosch Smart Home system can be used by other mobile devices. To
do this, first install the Bosch Smart Home app on the additional mobile
device and follow the instructions in the app.
‫ ܬ‬You can also use the explanatory videos and additional information on
our website as an additional aid for mounting, installing, starting up and
restoring the factory settings on your Bosch Smart Home controller:
→ https://www.bosch-smarthome.com/rom/controller-2
Resetting to factory settings
You have two options for resetting the Smart Home controller to the fac-
tory settings:
1. Reset via Bosch Smart Home app
Go to "More" then "System" in the app and select "Factory settings".
Follow the instructions.
2. Reset via the reset button
Press the reset button (5) until the status LEDs (2, 3, 4) on the front
flash red, release it briefly and press and hold it again until the LEDs
light up yellow. The device then restarts. Please note that it can take a
few minutes until the controller is ready for operation again.
݅ When resetting the Smart Home controller to the factory settings (using
the app or the reset button), only the Smart Home controller is reset.
All Smart Home devices that were previously integrated should be manu-
ally reset after resetting the controller.
↑Content
8-750-002-895 | V001 | 01/2024
QR code
for the Google Play Store
English | 10
Bosch Smart Home