Télécharger Imprimer la page

Bosch Smart Home controller II Notice D'utilisation page 9

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 23
Smart Home Controller II
Mounting instructions
݃ The standards and directives applicable in your country must be ob-
served during planning, set-up, operation and maintenance.
݅ The controller can be used in a horizontal position or mounted on the
wall.
݃ When selecting the mounting location and when drilling, pay attention
to the areas where electrical wires run, or to any supply cables.
݃ Please also note any additional information on the product.
݃ Always lay the cables of connected devices in such a way that they
cannot pose a hazard to people or pets. Please also note any additional
information on the product.
݅ For electronic devices (Smart Home hubs, routers, power supply units,
etc.), radio interference may occur under some circumstances if the dis-
tance between the devices is less than one metre. If this occurs, please
select a larger distance between the devices.
݅ Screws and plugs are not included in the box contents. Fillister head
screws or cylinder head screws with a head diameter of max. 8 mm and
a head height of max. 4 mm are recommended.
Start-up
Insert the network cable into the controller network connection (9) and a
free LAN port on your Wi-Fi router. Now insert the cable for the power sup-
ply unit supplied into the controller supply connection (10). Then plug the
power supply unit into a free socket. The status LEDs (2, 3, 4) show the
status of initialisation after starting through flashing codes (see product
overview).
݅ When you connect the controller to the internet for the first time, it au-
tomatically searches for software updates. If an update is required, it is
automatically downloaded and installed by the controller. This process
can take more than 30 minutes. The controller cannot be started during
this time. Please do not disconnect the controller from the power con-
nection for the duration of the process.
݅ The Smart Home controller II requires Ipv4 in the local network This is
usually the standard configuration for your router.
↑Content
8-750-002-895 | V001 | 01/2024
English | 9
Bosch Smart Home

Publicité

loading

Ce manuel est également adapté pour:

Bshc-2