Toro 21621 Manuel De L'utilisateur page 23

After Operation
Charging the Battery Pack
Important:
The battery pack is not fully charged when you purchase it. Before using the tool for the
first time, place the battery pack in the charger and charge it until the LED display indicates the battery
pack is fully charged. Read all safety precautions.
Important:
Charge the battery pack only in temperatures that are within the appropriate range; refer
to Specifications (page
Note:
At any time, press the battery-charge-indicator
button on the battery pack to display the current
charge (LED indicators).
1. Ensure that the vents on the battery and charger
are clear of any dust and debris.
Figure 20
1. Battery pack cavity
2. Battery pack venting areas 7. Charger LED indicator
3. Battery pack terminals
4. Battery-charge-indicator
button
5. LED indicators (current
charge)
13).
6. Handle
light
8. Charger venting areas
9. Adapter charger
2. Line up the cavity in the battery pack
with the tongue on the charger.
3. Slide the battery pack into the charger until it is
fully seated
4. To remove the battery pack, slide the battery
backward out of the charger.
5. Refer to the following table to interpret the LED
indicator light on the battery charger.
Indicator Indicates
light
Off No battery pack inserted
Battery pack is charging
Green
blinking
Green Battery pack is charged
Red Battery pack and/or battery charger is over or under
the appropriate temperature range
Red Battery pack charging fault*
blinking
g290533
*Refer to Troubleshooting (page 27)
information.
Important:
The battery can be left on the charger
for short periods between uses.
If the battery will not be used for longer periods,
remove the battery from the charger; refer to
Storage (page
g331152
21
(Figure 20).
for more
26).
(Figure 20)