Weber Summit E-670 Manuel D'utilisation page 10

LEAK CHECK PREPARATION
Check That All Burner Valves Are Off
Valves are shipped in the OFF position, but you should check to be sure that they are
turned off. Check by pushing in and turning clockwise. If they do not turn, they are off. If
they do turn continue turning them clockwise until they stop, then they are off.
m WARNING: The gas connections of your SUMMIT Gas Grill have
been factory tested. We do however recommend that you leak
check all gas connections before operating your SUMMIT Gas
Grill.
Remove Control Panel
Tools needed: Screwdriver, pliers, and towels.
A) Remove burner control knobs (1).
B) Open both doors. With a screwdriver, remove screws from the underside of control
panel (2).
C) Lift and remove battery housing located inside grill cabinet (3).
D) Using needle-nose pliers, disconnect wire terminals from the top of battery housing
(4). Do not pull on the wires; remove them by pulling on the wire terminals.
E) Place towels on the tops of both door assemblies.
This will protect control panel and door assemblies from getting scratched on
next step.
Tilt bottom of control panel forward. Lift slightly (5) and then rotate it face down to
F)
rest on tops of door assemblies. (Be careful not to break or disconnect wires for
the control panel LEDs.)
G) Carefully pull battery wires out from the inside of the grill cabinet (6).
H) Fully open right door. Place control panel on floor, leaning against towel covering
right door assembly (7).
◆
10
GAS INSTRUCTIONS
4
1
3
7
2
5
6
The grills illustrated in
this Owner's Guide may
vary slightly from the
model purchased.