Publicité
Les langues disponibles
Les langues disponibles
1. Press and hold the code button (3.5 or 3.6*) for five seconds until
the outdoor station emits a confirmation tone. Then release the
button.
2. Press 5 times briefly on the code button (you will hear a tone at
the outdoor station the first four times and a somewhat different
tone on the fifth depression) and wait for approximately 30
seconds (the power LED on the power box will go out briefly while
the power box restarts).
3. If an indoor station was registered on the ringer button then this
will now display 'UN'.
The code has now been deleted and the (new) indoor station can be
registered (again) as described in the 'coding' section.
*AC 110 only has the code button 3.5 while AC 120 has both; code
button 3.5 is for the upper ringer button while 3.6 is for the lower
ringer button.
OPERATION
Talk function
1. To call press the nameplate on the outdoor station. Depending on
the settings, this will cause the outdoor station, the power box and
the mobile indoor station to ring. *
The illuminated frame around the talk button will also flash on the
mobile indoor station.
2. Press briefly on the talk button within one minute** in order to
speak to the visitor (it will be approximately 2 seconds until the
connection is made). The display will show 'CA' while the call is
active.
3. You can activate the door opener with the door release button whi-
le the connection is established. The door opening will be indicated
optically and acoustically on the outdoor unit. If the visitor has not
entered then the door opener can be activated again by pressing
the door release button again.
4. End the call by pressing the talk button briefly. The illuminated
frame around the talk button is then off and the listening function
is back on standby.
*Note AC 120: if one of the two ringer buttons has been pressed then
the other ringer button is blocked for approximately 1 minute or until a
call is connected and ended.
**The ring tone sounds for this time. If the listening function has
stopped ringing, it is no longer possible to connect a call without
ringing again.
Intercom function
(only possible within one residence, not between residences)
If 2 mobile indoor stations have been configured on one ringer button
then it is possible to call from one listening unit to the other.
1. Press the intercom button (1.4) on the indoor station.
2. The second indoor station will ring.
3. Press the intercom button on the second indoor station to accept
the call.
4. Press the intercom button on one of the two indoor stations to
place the listener unit back to standby.
TECHNICAL DATA
Frequency (DECT): 1.8GHz
Range: up to 250m (open space)
Mobile indoor station
Power supply: 3.7V /650mAh LiIon
Standby time: approx. 24h
Charging cradle
Power supply: 6V DC / 300mA
Power box
Power supply: 12 volt DC / 2000mA
Power consumption on standby: ca. 60mA / ca. 1W
NOTES
Strong static, electrical or high frequency fields (discharges, mobile
telephones, radio systems, and microwaves) can cause the appliance(s)
to malfunction.
Cleaning and care
Disconnect mains-powered appliances before cleaning (remove the
plug). The surface of the casing can be cleaned using a soft cloth
dampened in a soap solution. Do not use scouring agents or chemicals.
Release collected dust from ventilation slits using a brush and a
vacuum cleaner if necessary. Do not hold the vacuum nozzle directly on
the appliance.
15 15
ENGLISH | AERCOM
Publicité
