Ryobi RBC52FSB Manuel D'utilisation page 21

1 Litre + 33 ml
2 Litres + 67 ml
3 Litres + 100 ml =
4 Litres + 133 ml =
5 Litres + 167 ml =
Filling the tank
■ Clean surface around
contamination.
■ Loosen the fuel cap slowly to release pressure and to
keep fuel from escaping around the cap.
■ Carefully pour fuel mixture into the tank. Avoid spillage.
■ Prior to replacing the fuel cap, clean and inspect the
gasket.
■ Immediately replace fuel cap and hand tighten. Wipe
up any fuel spillage. Move 9 m away from refuelling
site before starting engine.
NOTE: It is normal for smoke to be emitted from a new
engine during and after first use.
WARNING
Always shut off engine before fuelling. Never add fuel to
a machine with a running or hot engine. Move at least 9
m (30 ft) from refuelling site before starting the engine.
Do not smoke.
OPERATING THE STRING TRIMMER
See fi gure 9.
■ Hold the product with the right hand on the trigger
handle and the left hand on the left handle. Keep a
firm grip with both hands while in operation.
■ The product should be held at a comfortable position
with the trigger handle about hip height.
■ Always operate the product at full throttle. Prolonged
cutting at partial throttle will result in lubricant dripping
from the silencer.
■ Cut tall grass from the top down to prevent grass from
wrapping around the shaft housing and string head
which may cause damage from overheating.
■ If grass becomes wrapped around the string head,
stop the engine, disconnect the spark plug wire, and
remove the grass.
CUTTING TIPS
See fi gure 10.
■ Keep the product tilted towards the area being cut.
■ Do not use in dangerous environments.
English(Original instructions)
=
=
30:1
fuel cap to prevent
16
■ Use the tip of the string to do the cutting; do not force
the string head into the uncut grass.
■ Wire and picket fences cause extra string wear, even
breakage. Stone and brick walls, kerbs and wood may
wear string rapidly.
■ Avoid trees and shrubs. Tree bark, wood mouldings,
cladding and fence posts can be easily damaged by
the string.
STARTING AND STOPPING
See fi gure 13 - 14.
Choke position A
Choke position B
WARNING
Never start or run the engine inside a closed or poorly
ventilated area; breathing exhaust fumes can kill.
To start a cold engine:
1. Lay the product on a fl at, bare surface.
2. Set the ignition switch to the "I" (ON) position.
3. Push the primer bulb approximately 5 times.
4. Set the choke lever to position A (choke closed).
5. Pull the starter grip with a quick fi rm and consistent
upward motion until the engine starts.
6. Set the choke lever to position B (choke open).
7. Allow engine to warm up for 30 seconds prior to
operation.
To start a warm engine:
1. Lay the product on a fl at, bare surface.
2. Set the ignition switch to the "I" (ON) position.
3. Set the choke lever to position B (choke open).
4. Pull the starter grip with a quick fi rm and consistent
upward motion until the engine starts.
To stop the engine:
Set the ignition switch to the "O" (OFF) position.
OPERATING THE BRUSHCUTTER
See fi gure 11 - 12.
■ Hold the product with the right hand on the trigger
handle and the left hand on the left handle. Keep a
firm grip with both hands while in operation.
■ The product should be held at a comfortable position
with the trigger handle about hip height.
■ Maintain your grip and balance on both feet. Position
yourself so that you will not be drawn off balance by