Kärcher BRS 40/1000 C Mode D'emploi page 6

Recommended detergents:
Application
Routine cleaning of all
water resistant floors
Routine cleaning of
glossy surfaces (e.g.
granite)
Routine cleaning and
basic cleaning of indus-
trial floors
Routine cleaning and
basic cleaning of fine
stoneware tiles
Routine cleaning of tiles
in sanitary areas
Cleaning and disinfec-
tion in sanitary areas
Removal of coating
from all alkali-resistant
floors (e.g. PVC)
Removal of coating
from linoleum floors
Open the cover of the fresh water
reservoir.
Pour in water/detergent mixture.
Maximum temperature of the liquid
50°C
Close the cover of the fresh water
reservoir.
Driving to the Place of Use
Place the push handle vertically and
arrest.
Insert the transport wheel axles into
the borings on the appliance and
lock them.
Tilt the appliance to the side and
drive it to the place of use on its
transport wheels.
At the site of use:
Press the transport wheel release
button and pull the transport wheel
out.
Insert the transport wheels into their
holder until they stop.
6
English
Establish mains contact
Danger
Detergent
Check the mains cables of the machine
RM 746
each time before using the machine to
RM 780
see that it is not damaged. Never op-
RM 755 es
erate a machine with damaged cables.
Get the damaged cables replaced by
an electrician.
RM 69
ASF
RM 753
RM 751
RM 732
Insert the looped end of the exten-
sion cable in the strain relief hook.
Plug in the mains plug.
RM 752
Cleaning method
Move the appliance back and forth.
RM 754
Place the push handle vertically and
arrest.
Push the push handle down and
turn it to the position indicated
above.
Start up the appliance (see "Clean-
ing") and move it forward and back-
wards over the surface to be
processed.
Move the appliance from side to side
Place the push handle vertically and
arrest.
Push the push handle down and
turn it to the position indicated
above.
Start the appliance up (see "Clea-
ing".
Move the appliance to the left:
Press the left side of the push han-
dle down.
Move the appliance to the right::
Press the rlght side of the push han-
dle down.
Cleaning
Slide the lock of the push handle up
and swivel it to a comfortable work-
ing height.
Turn on the brushes by using the
switch for the brush drive.
Turn on the brush irrigation by using
the switch for the detergent solu-
tion.
Move the appliance over the sur-
face to be processed by the push
handle (see "Cleaning method").
Warning!
Risk of damage to the floor covering.
Do not operate the appliance on the
spot.
Polishing
Slide the lock of the push handle up
and swivel it to a comfortable work-
ing height.
Turn on the brushes by using the
switch for the brush drive.
Move the appliance over the sur-
face to be processed by the push
handle (see "Cleaning method").
Warning!
Risk of damage to the floor covering.
Do not operate the appliance on the
spot.
Note
To polish underneath furniture, the
fresh water reservoir can be removed.
Shutting Down the Appliance
Release the switch for detergent so-
lution.
Release the brush drive button.
Place the push handle vertically and
arrest.
Disconnect the mains plug.
Emptying the Fresh Water Res-
ervoir
Lift up the fresh water reservoir and
carry it to the disposal site.
Warning
Please observe the local provisions re-
garding the wastewater treatment.
Remove the cover of the fresh wa-
ter reservoir and pour out the liquid
via the notch.