Operation; General - Hatco Glo-Ray GRSSR-DL Série Manuel D'installation Et D'utilisation

English

General

Use the following procedure to turn on and operate a Glo-Ray
Round Heated Stone Shelf with Decorative Lamp.
WARNING
Read all safety messages in the IMPORTANT SAFETy
INFORMATION section before operating this equipment.
Make sure to clean and sanitize stone surface properly
after deep cleaning the surface using abrasives and before
placing food product on unit.
Startup
1. Clean and sanitize the stone surface using a clean, damp
cloth and a sanitizer approved for food contact surfaces.
2. Plug unit into a properly grounded electrical receptacle of
the correct voltage, size, and plug configuration. See
SPECIFICaTIONS section in this manual for details.
3. move the Power I/O (on/off) switch to the I (on) position.
• The decorative lamp will illuminate and the heated stone
shelf will energize.
CAUTION
BURN HAzARD: Some exterior surfaces on the unit will get
hot. Use caution when touching these areas.
4. Turn the Shelf Temperature Control to the desired
temperature setting.
• Turning the Shelf Temperature Control knob clockwise
will increase the temperature setting. Turning the Shelf
Temperature Control knob counterclockwise will
decrease the temperature setting.
5. allow the unit 30 minutes to reach operating temperature
before loading with preheated food product.
Form No. GRSSRDLm-0916
Decorative
Lamp
Power I/O (on/off)
Switch
Controls (GRSSR16-DL shown)
Shutdown
1. move the Power I/O (on/off) switch to the O (off) position.
• The decorative lamp and heated stone shelf will shut off.
2. Perform the "Daily
maINTENaNCE section of this manual.
7

OPERATION

Heated
Stone
Shelf
Shelf Temperature
Control
Cleaning" procedure in the