Operation; General - Hatco MVW Série Manuel D'installation Et D'utilisation

English

General

Use the following procedures to operate a mini Vertical Warmer.
WARNING
Read all safety messages in the Important Safety
Information section before operating this equipment.
NOTICE
Standard and approved manufacturing oils may smoke up
to 30 minutes during initial startup. This is a temporary
condition. Operate unit without food product until smoke
dissipates.
Startup
1. Plug the female end of the detachable power cord into the
power inlet on the back of the unit.
2. Plug the male end of the detachable power cord into a
properly grounded electrical receptacle of the correct
voltage, size, and
SPECIFICaTIONS section for details.
Power
Cord
Plugging in the Unit
BURN HAzARD: Some exterior surfaces on unit will get
hot. Use caution when touching these areas.
3. move the Power I/O Switch (on/off) to the I (on) position.
The indicator light on the switch glows when the unit is on.
4. Turn the Temperature Control to the desired temperature
setting.
• Turning the control clockwise toward "7" increases the
temperature.
• Turning the control counterclockwise toward "1"
decreases the temperature.
Form No. mVWm-0515
plug configuration. See
Power
Inlet
CAUTION
the
Temperature
Control
5. allow the warmer to preheat for approximately 30 minutes.
6. Lift the flip-up door and load pre-heated, pre-packaged
food product into the warmer.
Lift flip-up
Load product
Loading the mini Vertical Warmer
Shutdown
1. move the Power I/O Switch (on/off) to the O (off) position.
The indicator light on the switch will shut off.
7

OPERATION

Power I/O
Switch
Operator Controls
door.
here.