Publicité
INSTALLATION
INSTALLATION OPTIONS
Freestanding Unit - supported by pedestal/legs and
placed on a non-combustible floor surface in compliance
with clearance requirements for a freestanding stove
installation.
Alcove Unit - supported by pedestal/legs and placed
on a non-combustible floor surface in compliance with
clearance requirements for an alcove installation.
IMPROPER INSTALLATION
The use of other components other than stated herein
could cause bodily harm, heater damage, and void your
warranty. The manufacturer will not be held responsible
for damage caused by the malfunction of a stove due to
improper venting or installation.
AIR INTAKE & EXHAUST LOCATIONS
Fresh Air
Intake
7.34"
(187 mm)
FLOOR PROTECTION
This unit must be installed on a non-combustible floor
surface. If a floor pad is used, it should be certified or
equal.
USA - The floor pad or non-combustible surface should
be large enough to extend a minimum of 6" (153 mm) in
front, 6" (153 mm) on each side, and 1" (26 mm) behind
the stove. Floor protection must extend under and 2"
(51 mm) to each side of the chimney tee for an interior
vertical installation. A Floor Protector of 1" (26 mm) thick
is recommended for this installation.
Canada - Floor protector must comply with CAN/ULC
standards. Must extend 18" (458mm) past the front and
8" (203mm) beyond each side of unit.
CLEARANCES
Your pellet stove has been tested and listed for installation
in residential, mobile home/transportable building, and
alcove applications in accordance with the clearances
given in this manual. NOTE: The distance on the side of
your pellet stove may need to be greater than the minimum
required clearance for suitable access to the control
panel. For safety reasons, please adhere to the installation
Exhaust
Pipe
clearances and restrictions. Any reduction in clearance to
combustibles may only be done by means approved by a
regulatory authority.
6.28"
(160 mm)
7
A
B
B
C
A
Rear (through wall)
B
Side
C
Front
D
Rear (interior vertical)
F
E
G
J
J
© 2024 United States Stove Company
D
1"
25 mm
USA
6"
152 mm
CAN
8"
203mm
USA
6"
152 mm
CAN
18"
458mm
2"
50 mm
H
F
G
J
J
Publicité
