Publicité
• Do not exceed more than 4ft (1.22m) of pipe on a
horizontal run and use as few elbows as possible. If an
offset is required, it is better to install 45-degree elbows
rather than 90-degree elbows.
WARNING:
YOU MAY WANT TO LOCATE ANY UTILITIES OR
OBSTACLES INSIDE THE WALL BEFORE ATTEMPTING
THIS INSTALL. MAKE SURE TO KEEP IN MIND YOUR
UNIT'S CLEARANCE REQUIREMENTS.
1. Mark the area and then cut the wall for vent installation
if needed.
2. Install the wall thimble as specified by the manufacturer
(wall thimble sold separately)
3. Install venting.
VENTING YOUR PELLET STOVE INTO AN
EXISTING CLASS A 6" CHIMNEY SYSTEM
IMPORTANT:
IF YOU ARE INSTALLING YOUR PELLET STOVE AS
A REPLACEMENT TO AN EXISTING WOOD STOVE,
YOU CAN INSTALL YOUR PELLET STOVE USING THE
EXISTING CLASS A 6" VENTING SYSTEM.
1. You must have the existing chimney system cleaned
and/or inspected by a qualified chimney sweep before
proceeding with the installation of your pellet stove.
2. To the right is an example of an installation using part
number 860001, 3-6" transition into 6" connector pipe
(the illustration is only an example). Please conform
to any local building codes or regulations having
jurisdiction before you have a qualified installer
proceed with this installation.
© 2024 United States Stove Company
Ceiling
Support
TO STOVE
12
INSTALLATION
Existing Class 'A'
6" Chimney System
Support
Bracket
3" to 6" Pipe
Adapter
3" PL Vent
Clean Out Tee
Publicité
