Publicité
OPERATION INSTRUCTIONS
NEVER OPERATE THIS PRODUCT WHILE UNATTENDED
HOW YOUR HEATER WORKS
Your pellet heater operates on a timer based auger fuel
feed system, that is controlled by a digital circuit board.
The fuel is delivered from the auger into a burn pot, which
is the vessel where the combustion process takes place.
Based upon the heat ranges (1-5), the heater will feed the
appropriate amount of fuel to reach a set temperature
range. Note that the amount of heat produced by the heater
is proportional to the rate of the fuel that is burned. Your
heater is equipped with an automatic ignition system that
should ignite the fuel within 5-10 minutes from pressing
the ON button. As pellets fall into the burn pot and ignite,
outside air is drawn in to feed the fire by a combustion
blower. The post combustion gases are then pulled through
the heat exchanger as they are traveling out the exhaust.
As the heater warms up, room air is circulated around the
heat exchanger by means of a room air blower, distributing
warm air into the room. Because a forced draft pressure
is required for the combustion process inside your heater,
it is extremely important that the exhaust system be
properly maintained. And, that when operating your heater,
you make sure that the viewing and combustion doors are
properly closed and/or sealed.
CONTROL PANEL OVERVIEW
Turning the heater ON/OFF, as well as adjustments for the
fuel feed rate is performed by pressing the appropriate
button(s) on the control panel.
ON/OFF (Power)
• Pressing the "ON" button on the control panel will begin
the start-up sequence for the heater. Fuel will begin to
feed through the auger feed system then ignite after
approx. 5 minutes.
• Pressing the "OFF" button on the control panel will
cause the heater to enter its shut-down sequence. The
fuel feed system will stop pulling fuel from the hopper
and, once the fire goes out and the heater cools down,
the fans will stop running.
HEAT RANGE
• Pressing the "Heat Range" arrows, up or down, will
adjust the amount of fuel being delivered to the burn pot.
• The exhaust blower will start. Note that this appliance
pulses the exhaust blower in order to achieve the proper
air to fuel ratio, and to also aid in the cleaning of the burn
pot.
• Once the heater reaches a set temperature, the room fan
will come on.
WIFI
• Press the "WIFI" button to begin pairing the unit to your
phone.
DISPLAY
• Pressing the "Display" button toggles the display
between the heat range and the room temperature.
MODE
• Use the "Mode" button to switch between (M) manual
mode and (T) thermostat mode.
WIFI
ON/OFF
(POWER)
13
© 2024 United States Stove Company
DISPLAY
HEAT
MODE
RANGE
Publicité
