AVG VWD42S Manuel D'utilisation page 27

3. OPERATING YOUR APPLIANCE (
CONTINUED)
TEMPERATURE MEMORY FUNCTION
If the power is suddenly lost, the set temperature will be saved. Once the power is back on, the unit will be at
the same set temperature.
"CLOSE DOOR" REMINDER FUNCTION
If you forget to close the door or the door is not fully closed, there will be warning alarm after three (3)
minutes.
TEMPERATURE ALARM FUNCTION
If the interior temperature is higher than 23° C (73° F), the "HI" message is shown on the display panel and a
buzzer alarm will sound continuously after one hour. This indicates that the inner temperature is too high and
you should look for the reason. If the inner temperature is lower than 0° C (32° F) , the "LO" message is shown
on the display pane after fifteen minutes. The alarm and the malfunction indicator light go on at the same
time.
NOTES
If too many bottles are put in at once or the door has not been closed tightly, the unit will display the "HI"
message on the display panel. This is normal. Please wait five (5) minutes after closing the door and the "HI"
message will disappear.
It is normal that the display shows the "HI" or "LO" message from time to time. If it occurs frequently or lasts
for a long time, you can restart the unit by unplugging it, then re-plugging after five (5) minutes. If the
problem occurs again after restarting, please contact Customer Service.
Before reconnecting the power, wait three (3) to five (5) minutes. Otherwise, you could damage your
appliance. If you attempt to start the appliance before the end of this time delay, the appliance will not turn
on.
If you turn on the appliance for the first time or after a restart, or after it has been out of
operation for a long time, there may be a temperature difference between the temperature inside the
appliance and that on the LED display. This is a normal event caused by the duration of the activation period.
Leave the appliance turned on for several hours and the temperatures will stabilize during operation.
- 27