Publicité
Les langues disponibles
Les langues disponibles
2. INSTALLATION INSTRUCTIONS (
INSTALLING THE HANDLE
To install the handle, please follow these instructions:
1. Pull away the door gasket from the area where the handle is to be installed, on the left side, as shown in
Fig. 1. The gasket may be easily removed by hand, no tools are required.
2.
Align the handle with the screws to be installed. Tighten the screws using a Phillips head screwdriver until
the handle sets both flush and secured tightly against the door frame. DO NOT over-tighten as this will
cause damage to the handle assembly. Refer to Fig. 2. Replace the door gasket in its original position.
OPERATING CONDITIONS
Proper operation of the appliance is guaranteed only if the following conditions are met:
•
The temperature in the room where the appliance is located conforms to the climate class stated on
the appliance's rating label.
•
Maximum ambient relative humidity: RH75%.
The appliance must be installed at a sufficient distance from heat sources (i.e., ovens, central heating,
•
direct sunlight, etc.).
The appliance must be located in a dry area that it is protected against weather conditions .
•
•
Regular maintenance must be performed according to the instructions in this user's manual.
•
The ventilation openings on the appliance must not be covered or obstructed.
Conform installation (e.g. leveling, the capacity of the system corresponds to the specifications on the
•
rating label of the appliance).
)
CONTINUED
- 24
Publicité
