Publicité
INSTALLATION
M
OUNTING INSTRUCTIONS
Remove the four screws on the front cover and lift the cover. Remove the
black caps located on the three mounting holes. Mount the enclosure on
the wall using three screws. Be sure the electrical knockouts are at the
bottom of the enclosure in order to prevent water from entering the
controller. Insert the screws in the mounting holes and tighten. Fasten the
black caps onto the three mounting holes.
C
ONNECTIONS
To connect the equipment, refer to the wiring provided with this manual.
Set the voltage switch to the
appropriate voltage.
Use the electrical knockouts
provided at the bottom of the enclosure.
Do not make additional holes in the
enclosure, particularly on the side of
the enclosure when using a PC1-COM
computer communications module.
If metallic cable holders are used
to secure cables entering the enclosure,
use the ground plate provided with the
controller. Connect the ground wire to
the ground stud on the plate.
ALL WIRING MUST BE DONE BY AN AUTHORIZED ELECTRI-
CIAN AND MUST COMPLY WITH APPLICABLE CODES, LAWS
AND REGULATIONS. BE SURE POWER IS OFF BEFORE
DOING ANY WIRING TO AVOID ELECTRICAL SHOCKS AND
EQUIPMENT DAMAGE.
8
TC4-1CH.rev.01
Inside of the enclosure
Publicité
