Publicité
The maximum temperature is displayed, alternating with "P-1". Use
the adjustment knob to adjust the maximum temperature. Press the
push-button to store the value in memory.
The maximum opening is displayed, alternating with "P-1". Use the
adjustment knob to adjust the maximum opening for the first program
curve. Press the push-button to store the value in memory.
Second and Third Programs:
The starting day for the second (or third) program is displayed, al-
ternating with "P-2" (or "P-3"). The DAY/PRG. pilot light turns on. Use
the adjustment knob to adjust the starting day.
Follow the above sequence of steps to define the second and third
program curves. At the end of the sequence, "end" is displayed.
NOTE
: Starting days must follow each other on the time scale. The
controller starts the counter at the starting day for the previous program
plus one day. The highest starting day allowed is 99.
Activating / Deactivating the Program Sequence
Set the selection knob to PROGRAM. The current day flashes on
the display.
Press the push-button. The current state of the program sequence
flashes, i.e. ON/OFF. Use the adjustment knob to change the state of the
program sequence.
TC4-1CH
TC4-1CH.rev.01
19
Publicité
