Selecting The Brightness; Setting The Rear Output And Subwoofer Controller - Pioneer DEH-P8400MP Mode D'emploi

Section
Initial Settings
08

Selecting the brightness

You can select the display brightness. Initially
this mode is set to 12.
1 Press
OPEN
2 Press
FUNCTION
Press
FUNCTION
display.
3 Select the desired brightness with 2/3.
• The display shows
Setting the rear output and
subwoofer controller
This product's rear output (rear speaker leads
output and RCA rear output) can be used for
full-range speaker (
( ) connection. If you switch rear
Rear SP:S.W
output setting to the
nect a rear speaker lead directly to a subwoofer
without using an auxiliary amp.
Initially, the unit is set for rear full-range speaker
connection (
Rear SP:FULL
When rear output are connected to full range
speakers (when
can connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller's (low pass
filter, phase) built-in
auxiliary
S.W Control:EXT
46 En
to open the front panel.
to select
BRIGHT
until appears in the
BRIGHT
– .
0 15
) or subwoofer
Rear SP:FULL
, you can con-
Rear SP:S.W
).
is selected), you
Rear SP:FULL
or the
S.W Control:INT
.
Notes
• Even if you change this setting, there is no
output unless you switch the non fading out-
put (refer to page 42) or subwoofer output
(refer to page 41) in the Audio Menu on.
• If you change the subwoofer controller, sub-
. woofer output and non fading output in the
Audio Menu return to the factory settings.
1 Press
2 Press
Press
FUNCTION
play.
3 Change the rear output setting with 5/∞.
Pressing 5/∞ will switch between
(full-range speaker) and
:FULL
(subwoofer) and that status will be displayed.
Notes
• When no subwoofer is connected to the rear
output, select
• When a subwoofer is connected to the rear
output, set for subwoofer
• When the rear output setting is
you cannot change the subwoofer controller.
4 Change the subwoofer controller with
2/3.
Pressing 2/3 will switch between
S.W Control:INT
status will be displayed.
to open the front panel.
OPEN
to select
FUNCTION SW
until appears in the dis-
SW
Rear SP:S.W
.
Rear SP:FULL
Rear SP:S.W
and
S.W Control:EXT
.
Rear SP
.
,
Rear SP:S.W
and that