Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Section
Initial Settings
07
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Press
FUNCTION
Press
FUNCTION
in the display.
on or off with 5/∞.
2 Select
AUX
Pressing 5/∞ will switch
off and that status will be displayed (e.g.,
).
AUX :ON
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car's headlights are turned on. You
can switch dimmer on or off.
1 Press
FUNCTION
Press
FUNCTION
appears in the display.
on or off with 5/∞.
2 Select
DIM
Pressing 5/∞ will switch
and off and that status will be displayed (e.g.,
).
Dimmer :ON
34
En
to select
.
AUX
repeatedly until
appears
AUX
between on and
AUX
to select
.
DIM
repeatedly until
Dimmer
between on
Dimmer
Selecting the brightness
You can select the display brightness. Initially
this mode is set to 12.
1 Press
to select
FUNCTION
Press
repeatedly until
FUNCTION
appears in the display.
2 Select the desired brightness with 2/3.
• The display shows
–
0
Setting the rear output and sub-
woofer controller
This product's rear output (rear speaker leads
output) can be used for full-range speaker (
) or subwoofer (
SP:FULL
tion. If you switch rear output setting to the
, you can connect a rear speaker lead
SP:S.W
directly to a subwoofer without using an auxil-
iary amp.
Initially, the unit is set for rear full-range speaker
connection (
Rear SP:FULL
When rear output are connected to full range
speakers (when
Rear SP:FULL
can connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller's (low pass
filter, phase) built-in
S.W Control:INT
auxiliary
S.W Control:EXT
.
BRIGHT
Brightness
.
15
Rear
) connec-
Rear SP:S.W
Rear
).
is selected), you
or the
.
Publicité
Chapitres
Table des Matières
