Aiwa CA-DW935M Mode D'emploi page 15

SETTING THE SLEEP TIMER MICROPHONE MIXING
The unit can be turned off automatically at a specified time.
1
2
Press the SLEEP button.
Within 4 seconds, press the 44 or - button
to specify the time until the power is turned off.
Each time the button is pressed, the time changes between 5
to 240 minutes in 5-minute steps.
Specified time
To
check the time remaining until the power is turned
off
Press the SLEEP button once. The remaining time is displayed
for 4 seconds.
To cancel
the sleep
timer
Press the SLEEP button twice to turn off SLEEP on the display.
* If you press the SLEEP button while the power is off, the power
is turned on and the sleep timer starts to work so that the unit
will be turned off after 60 minutes.
To specify the timer until the power is turned off, press the
SLEEP button once again then press the < or + button
within 4 seconds.
@If the unit is turned off during tape playback, the - button for
the tape decks will not be released. Press the ¤/~ button to
release the 0 button.
1
2
3
to the
Adjust the volume of the microphone with the MIC
VOL control and the source to be mixed with the
VOLUME control.
To record the microphone mixing sound
Insert a cassette to be recorded on into deck 1 and press the
button.
m
If a microphone is placed too close to the speaker, a howling
sound (feedback) may be produced. If this happens, move the
microphone away from the speaker or decrease the main
volume.
The use of a unidirectional type microphone is recommended
to prevent howling.
Set the dubbing speed to normal. The microphone mixing sound
will not be recorded if high speed dubbing is selected.
r9vG/-/SH 15