Publicité
Les langues disponibles
Les langues disponibles
DUBBING A TAPE
SETTING THE CLOCK
Note that recording
is done on only one side of the tape,
Use Type I (normal)
tapes only.
1
2
3
4
5
6
Press the TAPE button.
Insert a tape to be recorded on into deck 1 with
the side to be recorded facing toward you.
Insert the tape to be played into deck 2 with the
side to be played facing toward you.
Press the 11 button then press the
button for
the deck 1 to enter recording
pause mode.
The >
button is pressed
simultaneously.
Press the HI-SPEED
DUBBING button to select a
dubbing speed.
Turn on HI-DUB
to dub at high speed.
Turn off HI-DUB
to dub at normal
speed.
Press the -
button for the deck 2.
The II button for the deck 1 is released
and recording
starts.
To
stop recording,
press the N/A
button for the deck 1.
44,
-
L
'"
—
When the AC cord is connected
for the first time, the time on the
display flashes.
Set the time as follows
while the power is off.
1
2
3
4
5
Press the II button.
The hour flashes.
(12-hour
standard)
'
'
Press the ++
or F-
button to designate
the
hour.
Press the 1I button to set the hour.
The hour stops flashing
and the minute
starts flashing
Press the -
or *
button to designate
the
minute.
Press
the
II
button
to set the minute
and
complete the setting.
The minute stops flashing
on the display and the clock starts
from 00 seconds.
To correct the current time
Press the POWER
button to turn the unit off and press the II
button twice.
Then carry out steps 2 to 5 above.
To
switch to the 12/24-hour
standard
While the power is off, press the II button twice so that the hour
flashes
and then press the
button to switch from 12-hour
to
24-hour
standard,
or vice versa.
Carry out steps 2 to 5 above to set the clock again.
If the clock display flashes while the power is off
This is caused
by a power interruption.
The current time needs
to be reset.
If power is interrupted
for more than approximately
12 hours, all
settings
stored in memory
after purchase
need to be reset.
ENGLISH
13
Publicité
