Publicité
Les langues disponibles
Les langues disponibles
POWER SUPPLY
CONNECTIONS
USING ON AC HOUSE CURRENT
Connect the AC cord as illustrated below.
.
L
0 to the
AC
inlet of the unit
+
0 to an AC outlet
CAUTION
Use only the supplied
AC cord.
Use with other cords may result
in the risk of fire.
USING ON BATTERIES
Open the lid of the battery
compartment
on the rear and insert
eight R20 (size D) batteries,
not supplied,
as illustrated
below.
Then close the lid.
,----1
.-ml
m
When disconnecting
the AC cord or removing
the batteries,
be
sure to turn the unit off (make sure the OPE/BATT
indicator
is
off)
To
switch from
AC
power supply to battery power supply,
disconnect
the AC cord from the AC inlet.
Batteries
wear excessively
when the cord is connected.
The batteries need to be replaced when:
The OPE/BATT
indicator
becomes
dim, the tape speed
slows
down, volume decreases,
or sound is distorted
during operation.
Notes on batteries
To avoid
damage
from
leakage
or explosion,
observe
the
following:
Insert the batteries
with the 0 and O marks correctly
aligned.
- Do not mix different
types of batteries
or old batteries
with new
ones.
Never recharge
the batteries,
apply heat to them or take them
apart.
Remove
dead batteries.
If liquid leaks from the batteries,
wipe thoroughly
to remove.
IMPORTANT
Make sure that the AC cord is disconnected
and batteries
are
removed
before connecting
speakers.
" Connect
only the supplied
speakers.
1
2
Position
the speakers.
To
couple with the speakers,
slide each speaker
down into
the guide brackets
on the center
unit until the height
is level
with the unit.
To
separate the unit from the speakers,
slide the speakers
up and off, while pressing
the speaker
release
knob.
b
Connect the speakers.
Connect
the right speaker
cord to the R terminals,
and the
left speaker
cord to the L terminals.
Connect
the speaker
cord with the white
broken
line to 0
and the other cord to O.
[x
Sound signals
can be input to this unit through
the AUX/VIDEO
jacks.
Use a cable with RCA phono plugs (not supplied)
to connect
the
external
equipment.
Connect
the red plug to the R jack, and the white plug to the L
jack.
To listen to the external source
Press the AUX button and play the equipment.
Refer
also
to the
operating
instructions
of the connected
equipment
for details.
4
ENGLISH
Publicité
