Publicité
Les langues disponibles
Les langues disponibles
Camera setting menu
9. Motion Detector Setting (MOTION DET)
1. Display SET UP on the monitor screen.
(Refer to Setup Menu Display on page 16 for details on display¬
ing the SET UP menu on the monitor screen.)
2. Move the cursor to MOTION DET and select ON or OFF by using
the joystick. Then press the CAM (SET) key when you select ON.
3. When you select ON, the motion detect setup menu appears.
You can mask the areas in this menu.
4. Move the cursor to MASK SET and press the CAM (SET) key.
48 mask areas appear on the monitor screen.
Refer to the Light Control Setting section on page 36 for masking
operations.
5. After masking areas, press the MON (ESC) key. The motion
detect setup menu appear on the monitor screen.
** SET UP **
CAMERA ID
OPT -»
ALC/MANUAL
ALC "1
SHUTTER
OFF
AGC
ON (MID)
SENS UP
X2 AUTO
SYNC
INT
WHITE BAL
ATW "l
MOTION DET
ON
^
AF MODE
MANUAL M
RET
SPECIALS '*
Motion detect menu
** MOTION DETECT **
LEVEL
+
DISPLAY MODE
ALARM
orr
MASK SET
RECOVER TIME
1MIN
RET
6. Move the cursor to ALARM and select ON or OFF by using the
joystick.
ON:
The alarm signal is supplied while the DISPLAY MODE is
activated.
OFF:
The alarm signal is not supplied while the DISPLAY MODE
is activated.
7. Move the cursor to DISPLAY MODE.
Press the CAM (SET) key to see the present setting. The areas
that detect the motions start blinking.
8. Move the cursor to LEVEL by using the joystick.
Use the joystick to obtain the optimum detection level. The "1"
cursor moves to the right or left.
Note:
Repeat the above procedures until you obtain the desired
adjustment.
9. Move the cursor to RECOVER TIME by using the joystick.
You can select the following recover times.
i—►OFF*-*1MIN*-»-2MIN-*-*-3MIN
L- 60MIN ■—* 30MIN *-*20MIN —
5MIN
10MIN
10. Move the cursor to RET and press the CAM (SET) key to return to
SET UP.
42
Publicité
