Panasonic WV-CS854A Manuel D'utilisation page 23

Setup menu
■ Auto Mode Selection
The menu screens follow the example for WV-CS854A.
1. To set auto mode
Move the cursor to AUTO MODE and select a mode by moving
the joystick to the right or left. Modes change as follows:
C
OFF-*SEQ —SORT— AUTO PAN— PATROL
□
** SET UP MEMO **
PRESET 1 *»
HAP '1
HOME POSITION OFF
SELF RETURN OFF
AUTO MODE AUTO PAH "»
AUTO PAH KEY AUTO PAN
DIGITAL FLIP ON
LOCAL/REMOTE
SPECIALl '1
CAMERA '»
RS485 SET UP '1
LOCAL
c
OFF—SEQ —SORT—AUTO PAN
2. When AUTO PAN is selected, set details as follows:
Move the cursor to AUTO PAN » and press the CAM (SET) key to
display the AUTO PAN setting menu.
3. To set a panning start position and panning end position
Follow the steps below.
(1) Move the cursor to POSITION SET and press the CAM (SET)
key.
The cursor moves to START.
(2) Move the joystick to the right or left to select a panning start
position and press the CAM (SET) key.
This determines the start position and the cursor moves to
END.
AUTO PAN setting menu
I ** AUTO PAN **
POSITION SETj
START
END
L H
PAN LIMIT OFF
ENDLESS OFP
DWELL TIME IS
RET
** AUTO PAN **
POSITION SET
START,
END
SPEED ■•■•I****
L H
PAN LIMIT OFF
ENDLESS OFF
DWELL TIME IS
RET
(3) Move the joystick to the right or left to select a panning end
position and press the CAM (SET) key.
This determines the end position and the cursor moves to
POSITION SET.
4. To set a panning speed
Move the cursor to SPEED, and move the joystick to the right or
left to set a panning speed.
The panning speed increases when the joystick is moved to the
right, and decreases when it is moved to the left.
Caution:
If the panning range is changed after the camera has
not panned for a long time or has been panning in the same
panning range, the picture may not be clear or noise may
appear. In this case, pan the camera fully several times. If this
does not eliminate the problem, refer servicing to qualified
service personnel.
** AUTO PAN **
POSITION SET START
END
SPEED
L H
PAN LIMIT OFF
ENDLESS
OFF
DWELL TIME
IS
RET
** AUTO PAN **
POSITION SET
START
END
SPEED
■•
L H
PAN LIMIT
OFF
ENDLESS
OFF
DWELL TIME IS
RET
5. To set pan limit ON/OFF
Move the cursor to PAN LIMIT and select ON or OFF by moving
the joystick to the right or left.
ON:
Manual pan is limited from the start point to the end point
specified by POSITION SET. Set endless turn to OFF before
pan limit is set to ON.
OFF:
Manual pan is not limited.
Note:
When ON is set, manual pan moves the camera away from
the other side of the start-end range.
23