Lamborghini Caloreclima EM 9/2-E Notice D'installation Et D'entretien page 33

ELECTRODES ADJUSTMENT
An ignition electrode and a control electrode are fitted on JM 9/2 burner.They should be posi-
tioned according to the indications supplied in the figure below.I
MPORTANT: the ignition electrodes and the control electrode must never touch the dif-
fuser, the draught tube or other metallic parts. If this were to happen they would no
longer work, thus impairing operation of the burner itself.
The position of the electrodes should always be checked after any work on the combustion
head.
WIRING DIAGRAM
WARNING:
- Do not invert the neutral with the phase.
- Make the connection to an effi cient earthing system.
- The electrical power line to the burner must be fi tted with an omnipolar switch with an ope-
ning of at least 3 mm between the contacts.
- The earth connection to the terminal board of the burner must be made with a cable at least
20 mm longer than the phase and neutral cables.
- Must be workmanlike performed and comply with the regulations in force.
NOTE: Always make sure that no more than two wires are connected to each terminal.
1
EC
FA
Control electrode
2 2 2 3 4 5 6 7 8
TR
M
MB
VP
1°
MV
2°
VS
1011123132 MA
9
PA
PGm
3
2
1
L1
N
T1
T2
S3
B4
CM
CM
MS
M
M
Tmf
TS
F
IG
L
N
TC
UK
33