Reely ROAD Mazda RX-7 Notice D'emploi page 41

The battery holder comprises of two plastic angles (1) and
two hook-and-loop tapes (2).
To insert the drive battery, loosen the two hook-and-loop-
tapes first.
Insert the drive battery into the chassis battery holder.
Fasten the drive battery with the hook-and-loop tapes so
that it cannot come loose or drop out.
e) Connecting the Drive Battery to the Speed Controller
First switch off the speed controller. The on/off switch is lo-
cated next to the speed controller see figure on the right.
To switch it off, push the slider (1) into the „OFF" position.
Then switch on the transmitter if you haven't done so yet
(see chapter 9. b) and c).
To prevent sudden start-up of the wheels and therefore uncontrolled starting of the model (e.g. if the trim-
ming for the drive is maladjusted), place the model vehicle on a suitable support (or starting box), so that the
wheels can turn freely in case of an error.
Do not reach into the drive. Do not hold the wheels.
Now connect the drive battery to the speed controller. Ensure correct polarity (red cable = plus/+, black cable = mi-
nus/-). Do not apply any force when connecting the battery plug to the connection of the speed controller.
Make sure that the cables do not get into the drive of the vehicle or the steering mechanics. Use cable binders for
fastening if required.
1
2
1
2
1
41