Publicité
Les langues disponibles
Les langues disponibles
• Press and hold the memory button
STOP button
for 5 seconds, depending on the user
memory you are in.
All values of the current user memory are delet-
ed and the device switches off.
8. CLEANING AND MAINTENANCE
• Clean the device and cuff carefully using a slightly damp
cloth only.
• Do not use any cleaning agents or solvents.
• Under no circumstances hold the device and cuff under
water, as this can cause liquid to enter and damage the
device and cuff.
• If you store the device and cuff, do not place heavy ob-
jects on the device and cuff. Remove the batteries.
9. REMEDY
and the START/
Error
message
or
34
Possible cause
The systolic or
or
diastolic pres-
sure could not
be measured.
The systolic or
diastolic pres-
sure is outside
of the measure-
ment range.
The cuff was not
or
attached cor-
rectly.
Solution
Please wait one minute and
repeat the measurement.
Ensure that you do not
speak or move during the
measurement.
Please wait one minute and
repeat the measurement.
Ensure that you do not
speak or move during the
measurement.
If the message is displayed
again, you should seek
medical assistance and
check the accuracy of your
procedure.
Please observe the infor-
mation in the chapter on
"Attaching the cuff".
Publicité
