Publicité
Les langues disponibles
Les langues disponibles
Body fat
Press this button to start the body fat measurement.
Enter your gender (figure 21), age, height and weight. Hold both hands on the handsensors during
measurement (figure 22). It will last about 8 seconds until the measurement is finished. After the mea-
surement, the fat advice symbol, the fat % (figure 23) and BMI (figure 24) will be displayed for approx.
30 seconds.
Error messages
"= = " " = =" (figure 25) means, that the contact to the handpulse sensors (or the chest belt) was not
sufficiently for a measurement. The reason for this can be that you have not grasped the two sensors
correctly. Start a new measurement with correctly placed hands resp. correctly placed chest belt.
"E-1" means, that no heart rate signal has been detected.
"E-4" appears (figure 26), if the fat % or BMI values are too low (<5) or too high (> 50).
Notes:
1) This computer has an automatic on/off function so that it switches on when the pedals move or when
any button is pressed, and turns into stand-by mode automatically if no signal has been received for
approx. 4 minutes.
2) In case of any abnormal functions, disconnect the device from power source and reconnect after some
minutes
38
Fig. 21
Fig. 23
Fig. 25
Fig. 22
Fig. 24
Fig. 26
Publicité
