Publicité
Les langues disponibles
Les langues disponibles
8 CONNECTIONS
• Do not plug in the AC cord until all connections have been
completed.
• Be sure to connect the left and right channels properly (left with
left, right with right).
• Insert the plugs securely. Incomplete connections will result in the
generation of noise.
• Use the AC OUTLETS for audio equipment only. Do not use
them for hair driers, etc.
Connecting the audio components
• When making connections, also refer to the operating instructions of the other components.
The power to these outlets is turned on and off when the power is switched between on and standby from the remote control unit or power
switch.
OUTPUT
CD player
R
L
DIGITAL AUDIO
DIGITAL AUDIO
R
L
Connecting a turntable
Connect the turntable's output cord to the AVR-1803/883's PHONO
jacks, the L (left) plug to the L jack, the R (right) plug to the right jack.
NOTES:
• This unit cannot be used with MC cartridges directly. Use a
separate head amplifier or step-up transformer.
• If humming or other noise is generated when the ground wire is
connected, disconnect the ground wire.
Turntable
(MM cartridge)
Ground
wire
MD recorder, CD recorder or other component
equipped with digital input/output jack
OUTPUT
INPUT
OPTICAL
DIGITAL AUDIO
DIGITAL AUDIO
COAXIAL
OPTICAL
OUTPUT
Connecting the DIGITAL jacks
Use these for connections to audio (video) equipment with digital output. Refer to page 24
for instructions on setting this terminal.
NOTES:
• Use 75 Ω/ohms cable pin cords for coaxial connections.
• Use optical cables for optical connections, removing the cap before connecting.
Connecting a CD player
Connect the CD player's analog output jacks
(ANALOG OUTPUT) to this unit's CD jacks using
pin plug cords.
L
R
R
L
R
L
B
CD player or other
component equipped
with digital output jacks
• Note that binding pin plug cords together with AC cords or placing
them near a power transformer will result in generating hum or
other noise.
• Noise or humming may be generated if a connected audio
equipment is used independently without turning the power of this
unit on. If this happens, turn on the power of the this unit.
AC OUTLETS
• SWITCHED
(total capacity – 120 W (1 A.))
The power to these outlets is turned on and off in conjunction with the
POWER operation switch on the main unit, and when the power is switched
between on and standby from the remote control unit.
No power is supplied from these outlets when this unit's power is at standby.
Never connect equipment whose total capacity is above 120 W (1 A.).
NOTE:
Only use the AC OUTLETS for audio equipment. Never use them for hair
driers, TVs or other electrical appliances.
Subwoofer jack
Connect the internal amplifier's subwoofer to the
subwoofer terminal. (Refer to page 17.)
R
L
Route the connection cords, etc., in such a way
that they do not obstruct the ventilation holes.
CD recorder or Tape deck
R
L
R
L
B
R
L
R
L
INPUT
OUTPUT
Connecting a tape deck
Connections for recording:
Connect the tape deck's recording input jacks (LINE IN or REC) to this unit's tape
recording (CDR/TAPE OUT) jacks using pin plug cords.
Connections for playback:
Connect the tape deck's playback output jacks (LINE OUT or PB) to this unit's tape
playback (CDR/TAPE IN) jacks using pin plug cords.
Connecting the AC OUTLETS
AC CORD
AC 120 V, 60 Hz
NOTE:
If humming noise is generated by a
tape deck, etc., move the tape deck
away.
ENGLISH
9
Publicité
