Moulinex ODACIO 3 DFC64M Mode D'emploi page 30

9 PUREEING/ PRESSING / MASHING (depending on model)
ACCESSORIES USED
- Bowl assembly (b), spindle (c), et "Maxipress" (l)
FITTING THE ACCESSORY
Press the release button (a4) to open the upper drive cover (a1).
- Place the bowl (b3) onto the lower drive (a3).
- Place the spindle (c) on the bowl drive (b3-1).
- Slide the desired disc (l2) onto the spindle (c) whilst turning it slightly so that the slots
under the disc come to a stop against the inside ribs of the bowl.
- Place the rotor (l1) in the central hole of the disc (l2) and push it in until it clicks into
place.
- Fit the lid (b2) onto the bowl.
- Close the upper drive cover (a1).
You should hear a click.
Tips
You can prepare with the disc:
• Large holes (l2-1): purées (up to 1 kg of cooked fruits or vegetables): potatoes, carrots,
cauliflowers.
• Small holes (l2-2): coulis or compotes with cored fruits (up to 500 g): tomatoes, grapes,
strawberries, raspberries, redcurrants, apricots, peaches.
Remark : If the rotor comes unclipped from the disc, check that you have fitted the correct
disc for the type of preparation and that your food is fully thawed or fully cooked.
CLEANING AND REMOVING THE "MAXIPRESS"
10
- Remove the disc / rotor assembly from the spindle (c).
- Press the clips on either side of the rotor to free the disc.
MINCING HEAD (depending on model)
11
ACCESSORIES USED
- Geared reducer assembly (n) and mincer head (o).
BEFORE FIRST USE
- Wash the mincer head in hot soapy water and dry it carefully immediately.
USE
Fitting the geared reducer onto the food processor.
11a
- Press the release button (a4) to open the upper drive cover (a1).
- Place the geared reducer onto the lower drive (a3):
- Close the upper drive cover (a1).
Assembling the mincer head:
11b
- Hold the body (o1) by the tube with the largest opening at the top. Next insert the screw
(o3) (longest pin first) into the body (o1).
- Fit the cutter (o4) onto the short pin with the cutting edges towards the outside.
20 20