KTM A54029974000 Instructions De Montage page 14

LED indications
1
2
3
CHARGE
(0.5V-14.3V)
LOW VOLT RECOVERY
BULK CHARGE
LED indication in sequence following connection to battery:
PRE-TEST:
See TEST result indications below.
A battery with integrated BMS (battery management system) / low voltage protection - LED #6 flashes
if the BMS / low voltage protection could not automatically reset.
The ampmatic ™ microprocessor adjusts according to the battery's size and condition .
CHARGE :
3
The special low voltage recovery program automatically engages for an over discharged battery.
Tests are conducted through-out the low voltage recovery program to determine battery and cell
health. LED #6 will flash if the battery could not recover successfully.
OPTIMIZE :
Current is delivered in pulses, aiding cell voltage equalization and improving the battery's
overall power delivery.
VOLTAGE RETENTION TEST :
hours to allow the program to determine the battery's ability to retain charge.
TEST RESULT & CONTINUOUS MAINTENANCE CHARGE:
is delivered only if the battery has lost charge due to connected vehicle circuitry. A refresh
cycle (return to LED #4) may be performed if the charge level has dropped significantly.
12
(illustration 1)
SELECTMATIC
condition is displayed for 10 seconds.
Battery
(LED #5 flashing) Delivery of current to the battery is interrupted for 12
TEST
70-100%
30-70%
0-30%
TEST
TEST - - -
MAINTAIN
OPTIMIZE
During the float charge period current
flashing / clignotante / intermitente / blinkt
/ parpadeando / knippert / blinkar
MAINTAIN
12h
+ TEST RESU T
OPTIMIZE
PULSE ABSORPTION
& EQUALIZATION
0%