Dehumidifier; Fan - Danby DPAC 7099 Manuel D'utilisation

OPERATING INSTRUCTIONS (cont'd)

DEHUMIDIFIER

1) Press the POWER SWITCH key (Fig. G) to
switch the unit on.
2) Press the MODE key (Fig. H) until the DRY
indicator light illuminates on the control panel
(Fig. I). Each depression of the MODE key will
advance to a different mode setting (Cool
Dehumidify - Fan
3) If the room temperature is > 25°C (77°F), fan
speed can be adjusted. Press the FAN key (Fig.
J) to select the desired FAN SPEED setting. Your
selection will appear on the control panel. Each
depression of the fan key will advance to a
different fan speed (High
as shown in Fig. K. Otherwise fan speed is fixed
to low.
Note: The warm air exchange hoses must vent
inside the room when using Dehumidify mode.
Fig. I

FAN

Note: During Fan mode, the exhaust hose does not have to be
vented outdoors.
1) Press the (on/off) key pad to switch on the unit (Fig. G).
2) Press the MODE key (Fig. H) until the DRY indicator
illuminates on the control panel (Fig. I). Each depression of the
MODE key will advance to a different mode setting (Cool
Dehumidify - Fan
3) Press the FAN key (Fig. K) to select the desired FAN SPEED
setting. Your selection will appear on the control panel. Each
depression of the fan key will advance to a different fan speed
(High - Med. - Low ) as shown in Fig. L.
Note: During dehumidifier mode, the exhaust hose does not
have to be vented outdoors.
- Auto )
- Med. - Low )
Fig. J
- Auto )
Important: The drain
hose must be installed
during dehumidifier mode
-
Fig. H
Fig. K
-
9
Fig. G
Fig. L